Remove-It Grout Haze Remover

5 L

£34.80 (Inc. VAT)

TT Paving Solutions Remove-It Grout Haze Remover is perfect for removing grout, plaster, and builders’ dirt from ceramic and porcelain, especially useful after the flags have been installed. Warning: never use on acid-sensitive surfaces

Removes grout haze Removes plaster Perfect for removing builders dust and dirt Ideal for initial acid wash after installation Not suitable for any wood or natural stone 100% biodegradable
Size:  5 L
Initial wash/grout haze removal: 1:5 -15m²
Builders clean refresh: 1:10 – 30m2
Maintenance clean: N/A
Number of pieces per pack: N/A
CONTAINS: Orthophasphoric acid <30%.
Finish (edge): N/A
Finish: N/A
Where can I uses this product? : porcelain, ceramics, cement, slate, quarry tiles, and unpolished stone. Always pre-test a small area.
Available: N/A
Country of origins: N/A
Tolerance: N/A
Frost resistant: N/A
Ensure Heavy Duty Cleaner is stored in a cool dry place and kept away from heat at all times. Keep out of the reach of children and pets. Do not mix with other chemicals. If in contact with eyes, rinse with water, if irritation persists seek medical advice. DANGER: IRRITANT H314: Causes severe skin burns and eye damage. P280: Wear protective gloveseye protection. P305-351-338: If in eyes rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P405: Store locked up. CONTAINS: Orthophasphoric acid <30%. Must read entire label and technical data sheet before use. It is the user’s responsibility to determine the suitability of the product for the intended use. How to use
    1. Depending on the level of soiling, dilute Grout Haze Remover to the correct dilution rates with either hot or cold clean water.
    2. Sweep or use our Ventosa vacuum on the area to remove loose soils or debris.
    3. Apply the cleaner to the surface and leave to act for 3 minutes, do not allow the product to dry into the surface.
    4. Agitate the product into the surface using the TT Macchia machine or deck brush.
    5. Once the desired result is achieved, extract all soils with clean water using our Ventosa vacuum or mop and bucket, and use cloths to remove any leftover residue.
    6. Repeat the process on extremely dirty surfaces.
    7. Rinse well with fresh clean water to ensure all residue is removed and again use our Ventosa vacuum, sponges, or cloths. Use with 1 cap of Clean-It PH neutral cleaner to 5lt of fresh clean water – this will dry streak-free, no need to rinse.
    8. Failure to follow the guide may result in damage to the surface.
  Technical Data Sheet
Please click on the link below to view the delivery information.

Click Here
Product has been added to your cart